Support
Plan for two people. A second person makes alignment and handling much easier.
Confirm the wall is smooth, clean, and sound. Self-adhesive murals need an even surface to bond properly.
Keep the liner (backing). You will need it for a high-quality transfer if you reposition or remove the mural.
Need a paste-style installation? Contact our team for the paste installation guide.
Step 1
A clean, smooth surface is the foundation of a long-lasting install.
Smooth out bumps and fill any cracks.
Remove switch plates and wall fixtures.
Wipe the surface with a warm, damp towel to remove dust and residue.

Step 2
Work in small sections to keep control of the mural and avoid trapped air.
Mark your preferred position on the wall.
Peel the backing a few inches from the top and press the top edge into place.
Remove the backing a few inches at a time while smoothing the mural onto the wall.
For wrinkles, rub gently toward the edges. If they remain, peel back and reapply.

Step 3
Panel alignment determines how the finished mural reads, so take your time on panel one.
Install and verify panel one before continuing.
Overlap panel two over panel one by 2 inches.
Match the pattern across the seam. Do not butt the edges together.
Repeat for each additional panel.

Step 4
Finish clean at ceilings, trim, and corners.
Use a straightedge and a fresh, sharp blade.
Cut slowly, and change blades often for the cleanest result.


Removing or repositioning
Our murals are removable and reusable. Keep the liner, which you will need for a high-quality transfer if you reposition the mural.
Our team can answer questions about installation, sizing, and printing.