Installations

Section

WHEN INSTALLING YOUR SELF-ADHESIVE WALL MURAL

REMEMBER...

BEFORE YOU BEGIN THERE ARE A FEW THINGS TO KEEP IN MIND. WE RECOMMEND A SECOND PERSON TO HELP INSTALL YOUR MURAL AND BE SURE TO INSPECT YOUR WALL. YOUR WALL MURAL REQUIRES A SMOOTH SURFACE TO ENSURE ADHESION AND PROPER APPEARANCE. IF YOU ARE INSTALLING A TRADITIONAL PAPER OR VINYL MURAL THAT REQUIRES PASTE, PLEASE CLICK HERE FOR OUR PASTE INSTALLATION PDF.

PREP THE WALL:

Smooth out any bumps and fill any cracks in the wall. Remove all switch plates and wall fixtures.

Clean the surface with a warm. damp towel so the mural will stick directly to the wall, avoiding any dust or residue on the surface.

Section

WHEN INSTALLING YOUR SELF-ADHESIVE WALL MURAL

REMEMBER...

PREP THE WALL:

Smooth out any bumps and fill any cracks in the wall. Remove all switch plates and wall fixtures.

Clean the surface with a warm. damp towel so the mural will stick directly to the wall, avoiding any dust or residue on the surface.

Peel and Stick:

Measure and mark your preferred mural position on the wall. Peel the backing a few inches down away from the top of the mural.

Apply the back of the mural to the wall and press it down.

Eliminate Excess Material:

Once the mural is completley adhered to the wall, cut back any excess material around ceilings, trim and wall edges.

Use a straightedge and a sharp blade for the best results. Cut slowly, and carefully.

WHEN INSTALLING YOUR SELF-ADHESIVE WALL MURAL

REMEMBER...

PREP THE WALL:

Smooth out any bumps and fill any cracks in the wall. Remove all switch plates and wall fixtures. Clean the surface with a warm. damp towel so the mural will stick directly to the wall, avoiding any dust or residue on the surface.

Peel and Stick:

Measure and mark your preferred mural position on the wall. Peel the backing a few inches down away from the top of the mural. Apply the back of the mural to the wall and press it down.

Eliminate Excess Material:

Once the mural is completley adhered to the wall, cut back any excess material around ceilings, trim and wall edges.Use a straightedge and a sharp blade for the best results. Cut slowly, and carefully.

Smooth out any bumps and fill any cracks in the wall. Remove all switch plates and wall fixtures.

Clean the surface with a warm. damp towel so the mural will stick directly to the wall, avoiding any dust or residue on the surface.

Measure and mark your preferred mural position on the wall. Peel the backing a few inches down away from the top of the mural.

Apply the back of the mural to the wall and press it down.

Once the mural is completley adhered to the wall, cut back any excess material around ceilings, trim and wall edges.

Use a straightedge and a sharp blade for the best results. Cut slowly, and carefully.